Related topics
Defining settings related to user preferences and individual customizing, page 102
Enabling Coordinated Universal Time (UTC) on the bottom
bar
You can set up the SN90 to show Coordinated Universal Time (UTC). When disabled,
the SN90 uses local time.
Prerequisites
To enable UTC time, your SN90 Processor Unit must be set up to accept the NMEA
ZDA datagram. The NMEA ZDA datagram contains the universal time code (UTC),
day, month, year and local time zone.
Context
This is an "on/off" switch. The time is shown on the bottom bar of the SN90 presentation.
Procedure
1
Open the
Display
2
Select
Display Options
Observe that the
3
Select
to open the page.
General
4
Select
UTC Time
5
Select
to save the selected settings and close the dialog box.
OK
Related topics
Defining settings related to user preferences and individual customizing, page 102
Selecting which tooltips to appear in the user interface
When you move the cursor over the echoes in the SN90 presentation, small "tooltips"
are shown to provide additional information. The
that are shown.
Context
Several tooltips can be shown in the SN90 presentation. When a tooltip is enabled,
the cursor location is detected and a small information box is shown. By default, the
information is related to the exact position of the cursor. Each tooltip represents a
specific piece of information, and they are listed separately.
381295/B
menu.
.
dialog box opens.
Display Options
to enable Coordinated Universal Time (UTC).
Operating procedures
page controls which tooltips
Tooltip
105