Installation; Introduction; Unpacking, Inspection, And Reshipment; Warranty Claims - Agilent Technologies 5517B Operation And Service Manual

SECTION II INSTALLATION

2-1. INTRODUCTION

2-2. This section provides installation instructions for the HP 5517B/C/D Laser Head including unpacking,
inspection and reshipment, installation, operating environment, and storage. Installation includes information on
grounding considerations, power supply requirements, power dissipation, fusing, dimensions, and mounting and
fixturing.

2-3. UNPACKING, INSPECTION, AND RESHIPMENT

2-4. The following paragraphs contain information for unpacking and inspection, warranty claims, laser tube
shipment, tagging for service, and packaging for reshipment.
TO AVOID HAZARDOUS ELECTRIC SHOCK, DO NOT PERFORM
ELECTRICAL TESTS WHEN THERE ARE SIGNS OF SHIPPING
DAMAGE TO ANY PORTION OF THE OUTER ENCLOSURE (COVERS,
PANELS, CONNECTORS, LEDS, ETC.).
ALWAYS REMOVE POWER FROM THE LASER HEAD PRIOR TO
CONNECTING OR DISCONNECTING LASER HEAD CABLING TO OR
FROM THE HP 5517B/C/D REAR PANEL.
2-5. Unpacking and Inspection
2-6. Inspect the shipping container for damage. If the shipping container or cushioning material is damaged, it
should be kept until the contents of the shipment have been checked for completeness and the instrument has been
checked mechanically and electrically. Procedures for checking electrical performance are given in Section IV. If the
contents are incomplete, if there is mechanical damage or defect, or if the instrument or some component fails the
performance tests, notify the nearest Hewlett-Packard office. If the shipping container is damaged, or the cushioning
material shows signs of stress, notify the carrier as well as the Hewlett-Packard office Keep the shipping materials
for the carrier's inspection. The HP office will arrange for repair or replacement at HP's option without waiting for a
claim settlement.

2-7. Warranty Claims

2-8. Contact the nearest HP Sales Office (see list at the end of this manual) for information relative to warranty
claims.
2-9. Laser Tube Shipment
NOTE
The laser tube assembly MUST be shipped in an approved HP container.
2-10. The laser tube assembly should only be shipped in an HP container designed for that purpose. In addition, the
container must indicate that the laser tube contains magnetic material. If it is necessary to ship a laser tube, contact
your nearest HP Sales Office for an approved container.

2-11. Tagging for Service

2-12. If the instrument is being returned to Hewlett-Packard for service, please complete a repair tag indicating type
of service required and attach it to the instrument.
2-19