Agilent Technologies 5517B Operation And Service Manual page 3

©Copyright Agilent
Technologies, Inc. 1987, 1993,
2000
All Rights Reserved.
Reproduction, adaptation, or
translations without prior
written permission is prohibited,
except as allowed under the
copyright laws.
Printed: August 2000
Printed in USA
Manual part number
05517-90047
Agilent Technologies, Inc
Santa Clara Division
Certification and
Warranty
Certification
Agilent Technologies certifies
that this product met its
published specification at the
time of shipment from the
factory. Agilent further certifies
that its calibration
measurements are traceable to
the United States National
Institute of Standards and
Technology (formerly National
Bureau of Standards), to the
extent allowed by the Institute's
calibration facility, and to the
calibration facilities of other
International Standards
Organization members
Warranty
Agilent warrants Agilent
hardware, accessories and
supplies against defects in
materials and workmanship for
a period of one year from date of
shipment. If Agilent receives
notice of such defects during the
warranty period, Agilent will, at
its option, either repair or
replace products which prove to
be defective. Replacement
products may be either new or
like-new.
Agilent warrants that Agilent
software will not fail to execute
its programming instructions,
for the period specified above,
due to defects in material and
workmanship when properly
installed and used. If Agilent
receives notice of such defects
during the warranty period,
Agilent will replace software
media which does not execute its
programming instructions due
to such defects.
For detailed warranty
information, see back matter
Safety Considerations
General
This product and related
documentation must be
reviewed for familiarization
with this safety markings and
instructions before operation.
This product is a safety Class I
instrument (provided with a
protective earth terminal).
Before Applying Power
Verify that the product is set to
match the available line voltage
and the correct fuse is installed.
Refer to instructions in Chapter
1 of the Manual.
Before Cleaning
Disconnect the product from
operating power before
cleaning.
Safety Earth Ground
An uninterruptible safety earth
ground must be provided from
the mains power source to the
product input wiring terminals
or supplied power cable.
Warning Symbols That
May Be Used In This
Book
Instruction manual symbol; the
product will be marked with
this symbol when it is necessary
for the user to refer to the
instruction manual.
Indicates hazardous
voltages.
Indicates earth (ground)
terminal.
Safety Considerations
(contd)
or
Indicates terminal is connected
to chassis when such
connection is not apparent
Indicates Direct current
Indicates Alternating current.
WARNING
BODILY INJURY OR
DEATH MAY RESULT
FROM FAILURE TO
HEED A WARNING DO
NOT PROCEED BEYOND
A WARNING UNTIL THE
INDICATED CONDITIONS
ARE
FULLYUNDERSTOOD
AND MET.
CAUTION
Damage to equipment, or
incorrect measurement data,
may result from failure to heed
a caution Do not proceed
beyond a CAUTION until the
indicated conditions are fully
understood and met
These CAUTION labels are
required by the United States
Center for Devices and
Radiological Health. Failure to
follow their instructions may
result in personal injury
This symbol indicates laser
radiation
For additional safety and
acoustic noise information, see
back matter
8.CD.L.03.11 97 R1 J CW1FL