Mercedes-Benz EQC 350 4MATIC 2021 Owner's Manual page 62

O Always comply with the manufacturer's
installation and operating instructions for
the child restraint system used.
O Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
® When fitting an ISOFIX child restraint sys‐
tem, also observe the following:
O When using a baby car seat in weight
group 0/0+ and a rearward-facing child
restraint system in weight group 1 on a
rear seat: adjust the front seat so that the
seat does not touch the child restraint sys‐
tem.
O When using a forward-facing child
restraint system in weight group 1:
remove the head restraint from the respec‐
tive seat, if possible. In addition, the back‐
rest of the child restraint system must lie as
flat as possible against the backrest of the
vehicle seat.
After the child restraint system has been
removed, replace the head restraints again
immediately and adjust them correctly.
O If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle, this will result in restrictions on the
maximum size setting for child restraint sys‐
tems in weight group 2 or 3.
Contact with the roof when the head
restraint is fully extended and locked in
place will not result in any restrictions on
use.
O The child restraint system must not be put
under strain between the roof and the seat
cushion and/or be fitted facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
O The child restraint system must not be put
under strain by the head restraint. Adjust
the head restraints as appropriate.
Occupant safety
° When fitting an i‑Size child restraint sys‐
tem, also observe the following:
O When using a rearward-facing child
restraint system: adjust the front seat so
that it does not touch the child restraint sys‐
tem.
O When using a forward-facing child
restraint system: remove the head
restraint from the respective seat, if possi‐
ble. In addition, the backrest of the child
restraint system must lie as flat as possible
against the backrest of the vehicle seat.
After the child restraint system has been
removed, replace the head restraints again
immediately and adjust them correctly.
59