Wheel Change - Mercedes-Benz EQC 350 4MATIC 2021 Owner's Manual

332 Wheels and tyres
Tyre pressure monitor active: the teach-in
R
process of the system is not yet complete.
The tyre pressures are already being moni‐
tored.
Compare the tyre pressure with the recom‐
#
mended tyre pressure for the current operat‐
ing condition ( page 330). Observe the
/
notes on tyre temperature (
% The values displayed in the on-board com‐
puter may deviate from those of the tyre
pressure gauge as they refer to sea level. At
high elevations, the tyre pressure values
indicated by a pressure gauge are higher
than those shown by the on-board computer.
In this case, do not reduce the tyre pressure.
Restarting the tyre pressure monitoring sys‐
tem
Requirements:
The recommended tyre pressure is correctly
R
set for the respective operating status on all
of the wheels ( page 329).
/
Restart the tyre pressure monitoring system in
the following situations:
The tyre pressure has changed.
R
The wheels or tyres have been changed or
R
newly fitted.
On-board computer:
Service
4
page 329).
/
Swipe downwards on Touch Control on the
#
left-hand side of the steering wheel.
The Use current tyre pressures as new refer-
ence values?
function display.
To restart, press Touch Control on the left-
#
hand side of the steering wheel.
The Tyre press. monitor restarted
shown in the multifunction display.
Current warning messages are deleted and
the yellow h warning lamp goes out.
After you have been driving for a few
minutes, the system checks whether the cur‐
rent tyre pressures are within the specified
range. The current tyre pressures are then
accepted as reference values and monitored.
Tyres
5
message is shown in the multi‐
message is
Be sure to also pay attention to the following
related topic:
Notes on tyre pressure (
/
R

Wheel change

Notes on selecting, fitting and replacing
tyres
You can ask for information regarding permitted
wheel/tyre combinations at a Mercedes-Benz
Service Centre.
& WARNING Risk of injury through incor‐
rect sizes of wheels and tyres
If wheels and tyres of the wrong size are fit‐
ted, the wheel brakes or components in the
brake system and in the wheel suspension
may be damaged.
Always replace wheels and tyres with
#
those that fulfil the specifications of the
original part.
page 329)