Installing The Jib Cradle - Frymaster FPGL30 Installation, Operation And Maintenance Manual

REAR OF
FRONT OF
FRYER FRYER
Anchor Strap or
Chain Restraint
Secure Strap or
Restraint to floor with
appropriate fastener.
NOTE: Bent link on
Chain Retstraint goes
to floor.
Leg or Caster
Mounting Bolt
2. Close fryer drain-valve(s).
3. Clean and fill frypot(s) to the bottom oil level line with cooking oil. (See Equipment Setup and
Shutdown Procedures in Chapter 3.)
2.7

Installing the JIB Cradle

Open the fryer door (typically the far-right door)
and remove the cross brace used for shipping sup-
port by removing the four screws (see Figure 1).
Install the JIB cradle shipped in the accessories
pack with the screws that were removed in the
cross-brace removal step (see Figure 2). If using
the solid shortening option, see Appendix A in the
rear of this manual for installation instructions.
Figure 1 Figure 2
Install the optional JIB splash shield to protect the
bottom of the JIB (see Figure 3).
Figure 3
2-11