4. Replace the paper tension unit as shown below. Tilt the unit
back and position the back notches on the unit over the rear
mounting pins of the printer. Press the levers open as you tilt the
unit toward you until the front latches click in place over the
front mounting pins located behind the paper bail.
5. Set DIP switch l-7 to off to turn off the cut sheet feeder mode.
Note: When DIP switch 1-7 is off, the printer uses the continuous
paper page length selected by DIP switches 2-1 and 2-2.
Removal of the cut sheet feeder is now completed. Be sure to store
the removed cut sheet feeder in its original box and packing
materials.
6. Replace the paper guide cover.
5-24
Using the Printer Options