Testing The Printer In The Cut Sheet Feeder Mode - Epson LQ-860 User Manual

6. Push the paper set levers back until they clamp the paper
against the guide rollers. The levers will not close completely if
too much paper is used. If this happens, remove some paper
from the stack and try again.
7. If you use the double-bin cut sheet feeder, you can select the
paper bin number with the control panel on the printer. Press
the TEAR OFF button to change between bin 1 and bin 2. The
printer beeps once if you select bin 1 and twice for bin 2. (You
can also select the bin with the ESC EM software command.)

Testing the Printer in the Cut Sheet Feeder Mode

When you perform the cut sheet feeder self test, the printer counts
the number of lines on the page. As shown below, the number of
lines counted is printed out at the bottom of the first test page. This
number is the default page-length setting. This setting, however, can
be overridden by software commands.
5-10
Using
the Printer Options