Initializing Your Printer; Reformatting The Hard Disk Drive - Epson EPL-N7000 Network Manual

Initializing Your Printer

To initialize your printer, turn on the printer while pressing the
Cancel Job button on the printer's control panel.
Caution:
c
Note that all changes made to the printer and network settings
are cleared when you initialize the printer using this method.
Therefore, do not initialize your printer except in the case you
forget the EpsonNet Config password.

Reformatting the Hard Disk Drive

To reformat the Hard Disk Drive, follow the instructions below.
Note:
Some printer models do not support this function.
1. Make sure the printer is turned off.
2. Hold down the Down button while you turn on the printer.
3. When you see the message Support Mode on the LCD panel,
select HDD Format in the support menu.
Note:
❏ After reformatting the Hard Disk Drive, the printer will
automatically reboot.
❏ When you want to erase only the fonts installed from the optional
Adobe PostScript 3 (PS3), follow steps 1 through 3 above. Select
PS3 HDD Init when the optional Adobe PostScript 3 ROM is
installed.
❏ When installing a Hard Disk Drive from a different printer,
reformat it with this function.
Troubleshooting
4
4
4
4
4
4
4
4
4
4
4
4
227