Epson EPL-N7000 Network Manual page 204

Port Number:
Enter the port number of the proxy server (from 0 to 65535).
Get Printer Attributes:
When you select this box and click OK, EpsonNet Internet
Print communicates with the printer and acquires
information, so it may take a few minutes before a message
appears. This setting is available only when creating a port.
Get status every 20 sec.:
Select this box when you want to receive printer status updates
at regular intervals (every 5 seconds during printing and every
20 seconds when idle). If you select this box, a message will
appear if an error occurs during printing. You can also check
the printer status by double-clicking the printer icon.
OK button:
Saves the settings.
Cancel button:
Cancels any changes.
Note:
❏ The settings can be changed after setting up the printer. In the
printer Properties dialog box, click the Ports tab, and click the
Configure Port button to change the settings.
❏ Be aware that if you connect to the Internet using a dial-up
router and select the Get status every 20 sec check box, you
may be charged for the extra line connection.
❏ When you select the Get Printer Attributes check box and
click OK, an error message may appear. Be sure that the printer
power is on, and the printer is connected to the network.
❏ If the printer power is off or there is a problem in the network,
the Get status every 20 sec check box is automatically
cleared. If this happens, make sure that the printer power is on
and the printer is correctly connected on the network, and then
select the Get status every 20 sec check box again.
204
Network Software