Setting Host Device Communications Conditions
You can set parameters for communications between the Reader/Writer and host device. If you change
any of these settings, you must first save them and then reset the Reader/Writer to enable using them.
Fixed IP Address Setting
Default setting: 192.168.1.200
Subnet Mask Setting
Default setting: 255.255.255.0
Gateway Address Setting
Default setting: 192.168.1.254
Setting the Web Password
You can set a password for logging in from a Web interface. The password can be up to 15 ASCII
characters. No password is set by default.
If a Web password is set, a dialog box requesting entry of the password will be displayed when the
initial Web server interface is displayed. If the correct password is entered, a normal Web interface can
be used.
Setting Reader/Writer Operation
You can set parameters that control Reader/Writer operation. If you change any of these settings, you
must first save them and then reset the Reader/Writer to enable using them.
Names and Functions of Components
Section 2
RFID System
39
User's Manual