Connecting The Printer To Your Computer; Running The Test - Epson ActionPrinter 2250 User Manual

Running the test

1. Make sure the printer is turned off.
2. While holding down the
The printer gives two long and two short beeps, and then it
loads the paper automatically and begins the self test.
The printer prints characters in the current font and character
table. Here is part of a typical self test:
Note:
If the paper cassette is empty when you turn the power on,
the printer beeps three times and the
paper as described above and press the
self test.
3. To stop the self test, turn off the printer.
If the self test does not work properly, contact your dealer.

Connecting the Printer to Your Computer

If the self test prints correctly, you're ready to connect your printer
to the computer. You need a parallel printer cable to connect your
computer to the printer's built-in parallel interface.
Follow these steps to connect the parallel interface cable:
1. Make sure both the printer and computer are turned off; then
plug the cable connector securely into the printer's interface
connector.
LF/FF
READY
LF/FF
Setting Up the Printer
Running the Self Test
light flashes. Load
button to start the
1-11