Alarm Trigger & Remote Start Diagnostics - CrimeStopper SP-502 Installation Handbook

ALARM TRIGGER DIAGNOSTICS
This systems includes disarm diagnostics, through the LED light, that will help in determining what caused the last
trigger of the alarm system. This is a valuable tool in determining how the vehicle was tampered with or if there is a
false alarm problem in which case you can make the necessary adjustments to correct the problem.
When the system is disarmed with the remote you will hear the normal 2 chirps, then 4 quick chirps that indicate the
alarm was triggered while you were away. Check the LED light for a sequence of flashes:
1 LED Flash = Shock Sensor Violation
2 LED Flashes = Door Violation
3 LED Flashes = Hood Violation
4 LED Flashes = Ignition Violation
5 LED Flashes = Trunk Violation
Diagnostics will reset when the Ignition is turned on or when the system is re-armed.
REMOTE START DIAGNOSTICS
If the system flashes the LED and Parking Lights one to seven times and doesn't attempt remote. The LED
will continue to flashing the error code until the ignition is turned on, it means the following:
1 Parking Light Flash (1 LED Flash) = Problem with Brake Switch.
2 Parking Light Flashes (2 LED Flashes) = Problem with Hood Switch.
3 Parking Light Flashes (Solid LED) = Valet Service Mode.
5 Parking Light Flashes (5 LED Flashes) = Ignition On before Remote Start.
6 Parking Light Flashes (6 LED Flashes) = Tach Problem (Tach signal without engine running)
7 Parking Light Flashes (7 LED Flashes) = Manual Transmission Error.
Note: In Manual Transmission Mode, the LED will Flash 3 times if the parking park is not set.
29