CrimeStopper SP-502 Installation Handbook page 7

ORANGE: (-) 500mA Starter Disable/Anti-Grind Output
This wire should be connected to the Yellow wire of the pre-wired relay socket for the starter disable. Connect the
White wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect
each half to a Green wire on the relay socket. This output also turns on with remote start to function as an "Anti
Grind" wire to prevent the starter from grinding if you get in your car and turn the key too far after it was remote
started.
CONNECT TO
ORANGE WIRE
OF ALARM
PRE-WIRED
STARTER DISABLE
RELAY & SOCKET
START OUTPUT
FROM ALARM
6-PIN HARNESS
WIRING: 12-PIN Connector Cont.
STARTER DISABLE:
IGN. SWITCHED
STARTER WIRE
YELLOW
WHITE
BROWN
CUT
GREEN
GREEN
7
IGNITION SWITCHED
"ON" & HOT THROUGH
CRANKING
STARTER
MAKE CERTAIN TO
CONNECT BROWN
WIRE TO STARTER
MOTOR SIDE!!!