Shock Sensor - CrimeStopper SP-502 Installation Handbook

SHOCK SENSOR: The sensor supplied with this system does not require any additional wiring. Simply mount the
sensor in a suitable location, plug it in, and adjust the sensitivity. There are 2 LED's on the shock sensor to assist
you in adjusting sensitivity. The Blue LED indicates the "Warn Away" level and the Red LED indicates a full alarm
shock sensor violation.
NOTE: Your sensor may have 1 or 2 adjustment knobs (depending on model) to adjust both Pre-Warn and alarm
trigger.
(-) TRIGGER
(-) PRE-WARN
12 VOLTS
GROUND
WIRING: 4-PIN Shock Sensor (22 Gauge wires)
BLUE LED
GROUND
12 VOLTS

SHOCK SENSOR

(Pre-Warn)
Adjustment
YELLOW
ORANGE
RED
BLACK
11
(Trigger)
RED LED