Alarm Trigger Diagnostics; Remote Start Diagnostics - CrimeStopper SP-402 Operating Instructions Manual

ALARM TRIGGER DIAGNOSTICS

This systems includes disarm diagnostics, through the LED light, that will help in determining what caused the
last trigger of the alarm system. This is a valuable tool in determining how the vehicle was tampered with or if
there is a false alarm problem, in which case you can make the necessary adjustments to correct the problem.
When the system is disarmed with the remote, you will hear the normal 2 chirps, then 4 quick chirps that
indicate the alarm was triggered while you were away. Check the LED light for a sequence of flashes:
1 LED Flash = Shock Sensor Violation
2 LED Flashes = Door Violation
3 LED Flashes = Hood Violation
4 LED Flashes = Ignition Violation
5 LED Flashes = Trunk Violation
Diagnostics will reset when the Ignition is turned on or when the system is re-armed.

REMOTE START DIAGNOSTICS

The system has built-In Remote Start Diagnostics. If Remote Start fails, the Status LED and Parking
Lights flash one to seven times to indicate an error code. The LED will continue flashing the error
code until the ignition is Turned On; it means the following:
1 Parking Light Flash (1 LED Flash) = Problem with Brake Switch.
2 Parking Light Flashes (2 LED Flashes) = Problem with Hood Switch.
3 Parking Light Flashes (Solid LED) = Valet Service Mode.
5 Parking Light Flashes (5 LED Flashes) = Tach Problem (Ignition On before Remote Start).
7 Parking Light Flashes (7 LED Flashes) = Manual Transmission Error.
Note: In Manual Transmission Mode, the LED will Flash 3 times if the parking park is not set.
This system includes disarm diagnostics, through the BLUE LED light, that will help in determining
7 Parking Light Flashes = Manual Transmission Mode Error.
15