Table of Contents
Advertisement
10. DISARM WITH AUX. OUTPUT (TRUNK POP)
Controls whether the system will or will not DISARM when the trunk pop or AUX. feature is used. When the feature is
turned on the unit will DISARM when opening trunk or other AUX feature. Factory Default setting is OFF
11. SIREN CHIRP COUNTDOWN W/ PASSIVE ARMING
With this feature ON, the alarm will begin to chirp the siren when passive arming sequence begins. A very small siren
chirp is emitted every second for approximately 25 seconds until the system passively arms. Default setting is OFF.
12. 5/60 Sec. DOOR/ZONE OPEN WARNING
This setting changes the time that the alarm system starts to monitor the Door, Hood, or Trunk Zones. Change setting
to 60 Sec. for vehicles with a delayed dome light prevent warning chirps. Factory Default setting is 5 Sec.
13. REMOTE START RUN TIME
Set engine run time for remote start for 15 or 25 minutes. Factory Default setting is 15 min.
14. DOOR LOCK WITH REMOTE START
This option controls whether the unit will lock the doors after a remote start whether alarm system is armed or not. This
prevents an unlocked/unattended running vehicle. Factory Default setting is OFF.
15. DOOR LOCK WITH ABORTED/TIMED OUT REMOTE START
This option controls whether the unit will lock the doors after a remote start is aborted or finished with the run time and
one entered the vehicle. whether alarm system is armed or not. This
16. PARKING LIGHTS ON WITH DISARM
Keeps parking lights on instead when system is disarmed to assist in locating your vehicle in a crowded parking lot or
structure. Light will stay on for 30 Sec. or until Ignition is turned on. Factory Default setting is OFF.
The 4-position DIP SWITCH bank is hidden below the small access door on the top of the alarm control
module. These switches are used to select options as follows:
Dip Switch Number
#1 Gas / Diesel
#2 Tach/Tachless or Vacuum
#3 Crank Time (0.8 or1.25 Sec.)
#4 Engine or Tachless Monitor
SEE DESCRIPTIONS ON NEXT PAGE.
OPTION PROGRAMMING
REMOTE START ENGINE OPTIONS
Settings
ON = Gas
ON = Tach/Tachless
ON = 0.8 Sec.
ON = Tachless
OFF = Diesel
OFF = Vacuum
OFF = 1.25 Sec.
OFF = Engine Monitor (GRAY WIRE)
Advertisement
Table of Contents
