Table of Contents
Advertisement
Table 7-11 SmartTrunking Configuration Screen Field Descriptions
Use this field...
SmartTrunk Group
SmartTrunk Logical Port
SmartTrunk Status
SmartTrunk Group Id
Port
SmartTrunk Protocol
NO CHANGE field
SAVE
SHOW
The ports used for each trunk must all be on the same internal switch chip, which is synonymous
with the SmartTrunk Group ID.
Table 7-12 SmartTrunk, Ports Associated with Group IDs
Group IDs
1
1 thru 8
Ports
To...
See the SmartTrunk Group number associated with the
logical ports listed under SmartTrunk Logical Port.
See the list of Logical Ports associated with the SmartTrunk
Group.
Enable or disable the trunk group.
Select from 1 to 6 trunks. This is the group ID of the
SmartTrunk group. Identifies the chip set to be used. Refer
to
Table 7-12
Enter the number of the port that you want to add or remove
from the trunk. Refer to
with each group ID.
Enable or disable the SmartTrunk Protocol on the selected
port.
Add or delete ports from group ID. Steps to ADD,
REMOVE, and NO CHANGE (default setting). This setting
causes the port selected in the Port field to be added,
deleted, or not changed when the SAVE command is used.
Save the current values on the screen.
Display the SmartTrunk group listed under the SmartTrunk
Group ID field.
Table 7-12
identifies the ports associated with each group ID.
2
3
9 thru16
17 thru 24
SmartTrunking Configuration Screen
for the ports associated with each group ID.
Table 7-12
4
25 thru 32
Device Control Menu Screens
for the ports associated
5
6
33 thru 40
41 thru 48
7-25
Advertisement
Table of Contents
