Removing The Existing Dram Simm - Enterasys Matrix 7G4280-19 Hardware Installation Manual

Memory Replacement Procedures
Figure B-6
1 Connector arms
Installing the DRAM SIMM
To install a DRAM SIMM, refer to Figure
1. Push the connector arms away from the DRAM SIMM enough to insert the DRAM
SIMM into the connector contacts.
2. Insert the DRAM SIMM straight down between the connector contacts enough for the
tabs on the connector arms to align with the two alignment notches.
3. Push the DRAM SIMM down into the connector contacts. Then rotate the two
connector arms toward the DRAM SIMM to lock it into place.
4. This completes the installation of the DRAM SIMM.
B-8 Mode Switch Settings and Installing Options

Removing the Existing DRAM SIMM

À
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
Á
Â
2 DRAM SIMM
B‐7 and proceed as follows:
À
3 Connector contacts