Memory Locations and Replacement Procedures
Figure B-4
1 Connector arms
Installing the DRAM SIMM
To install the memory module, refer to Figure
1.
With the connector arms set in the open position, insert the DRAM SIMM between the
connector fingers and push the DRAM SIMM into the connector until the tabs on the
two connector arms pull in towards the alignment notches.
2.
Push the DRAM SIMM further into the connector until the two DRAM SIMM
alignment notches and the tabs on the two connector arms lock the DRAM SIMM into
place.
B-6 Mode Switch Bank Settings and Optional Installations
Removing the Existing DRAM SIMM from 7H4382-25
À
Caution: Observe all antistatic precautions when handling sensitive electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
Â
2 Memory module
B‐5 and proceed as follows:
Á
À
3
Connector