Connecting to COM Port for Local Management
Figure 3-15
1 UTP straight-through cable
2 RJ45 COM port
Connecting to a VT Series Terminal
To connect a VT Series terminal to an Enterasys Networks DFE module COM port
(Figure
female adapter, and proceed as follows:
1.
Connect the RJ45 connector at one end of the UTP straight‐through cable to the COM
port on the Enterasys Networks module.
2.
Plug the RJ45 connector at the other end of the UTP straight‐through cable into the
RJ45‐to‐DB25 female adapter.
3.
Connect the RJ45‐to‐DB25 adapter to the port labeled COMM on the VT terminal.
4.
Turn on the terminal to access the Setup Directory and set the following parameters:
3-26 Installation
Connecting an IBM PC or Compatible
Ã
3‐16), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Â
with RJ45 connectors
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Á
À
3 RJ45-to-DB9 PC adapter
4 IBM PC or compatible device