Connectivity
Network Expansion Module (NEM) Option
The 7G4282‐41 option slot provides access to an installed network expansion module.
Refer to the Enterasys Networks web site for a current listing of the available NEMs.
Specific installation instructions are shipped with each NEM.
CONNECTIVITY
7G4202-60
The 7G4202‐60 has 10BASE‐T/100BASE‐TX/1000BASE‐T compliant ports via 60, fixed RJ45
front panel connectors.
7G4282-41
Depending on how the 7G4282‐41 (Figure
•
40, 10BASE‐T/100BASE‐TX/1000BASE‐T switched ports connected through 40, fixed
RJ45 front panel connectors, or
•
40, 10BASE‐T/100BASE‐TX/1000BASE‐T switched ports and an optional network
expansion module.
MANAGEMENT
Management of the module can be either in‐band or out‐of‐band. In‐band remote
management is possible using Telnet, Enterasys Networks' NetSight
application, or WebView™ application. Out‐of‐band management is provided through
the RJ45 COM (Communication) port on the front panel using a VT100 terminal or a
VT100 terminal emulator.
Switch Configuration Using WebView
Enterasys Networks' HTTP‐based Web management application (WebView) is an
intuitive web tool for simple management tasks.
Switch Configuration Using CLI Commands
The CLI commands enable you to perform more complete switch configuration
management tasks.
For CLI command set information and how to configure the module, refer to the Enterasys
Matrix DFE‐Platinum Series Configuration Guide.
1-4
Introduction
1‐1) is configured, it can support up to:
®
management