Table of Contents
Advertisement
INFORMATION ABOUT REPLACEMENTS
6.5 Replacement of AdBlue® filter
Warning
•
Before proceeding with operation, read
•
Do not lubricate gaskets A with oil or fuel.
•
Filter D includes gaskets A in the package.
•
Avoid any type of contamination during replacement.
•
Before starting any operations, make sure the key on the machine's panel is OFF and the
AdBlue® pump has executed the circuit emptying operation.
1. Loosen cap B.
2. Remove cap B and extract filter bracket C.
3. Extract filter D.
4. Use warm AdBlue® to clean the seat of filter D on
pump E if impurities are detected.
5. Lubricate the A gaskets with AdBlue® or distilled
water.
6. Place the filter bracket C together with filter D inside
pump E.
7. Tighten cap B (tightening torque of 20 Nm).
Par. 3.2.2
6.11
6.12
6
51
EN
Advertisement
Table of Contents
