Table of Contents
Advertisement
INFORMATION ABOUT REPLACEMENTS
6 INFORMATION ABOUT REPLACEMENTS
6.1 Engine oil replacement
Danger:
•
Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
Important:
•
Before proceeding with operation, read
Important :
•
Place engine on level surface to ensure accurate
measurement of oil level.
Before proceeding, perform the operation described in
Par. 6.2
- Point
NOTE: Perform this operation with warm engine, to get a
better fluidity of the oil and get a full discharge of oil and
impurities contained in it.
1. Loosen the oil filler cap A (Fig. 6.1).
2. Remove the oil dipstick B.
3. Remove the oil drain plug D and the gasket E (the oil
drain plug is on both sides of the oil sump).
4. Drain oil in an appropriate container (For the exhausted
oil disposal, refer to (
SCRAPPING
).
5. Replace gasket E.
6. Tighten the drain oil plug D (tightening torque at 50 Nm).
7. Perform the operation described in
8. Add the type oil recommended (
Important :
•
Do not exceed the MAX level on the dipstick.
•
Do not use the engine with the oil level below the MIN.
9. Fit and remove the oil dipstick B to check the level. Pour
in fluid until reaching the MAX level mark.
10. Upon completion, reinstall the oil dipstick B completely.
11. Tighten the cap A.
NOTE: Click on the icon to play the procedure.
Cap. 3
Par. 6.6 DISPOSAL and
Par. 6.2
- point 2 to 5.
Tab. 2.1
and
Tab. 2.2
.
6.1
6.2
).
6.3
https://www.youtube.com/
embed/T7XFP3Vn_q0?rel=0
6
47
EN
Advertisement
Table of Contents
