Information About Replacements - Kohler KDI 2504TM Owner's Manual

6
Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
•
6.1 Engine oil replacement
• Place engine on level surface to ensure accurate
measurement of oil level.
• Before proceeding, perform the operation described in
Par. 6.2
- Point 1.
NOTE: Perform this operation with warm engine,
to get a better fluidity of the oil and get
a full discharge of oil and impurities
contained in it.
1. Loosen the oil filler cap A (Fig. 6.1).
2. Remove the oil dipstick B.
3. Remove the oil drain plug D and the gasket E
(the oil drain plug is on both sides of the oil sump).
4. Drain oil in an
the exhausted
Par. 6.5 DISPOSAL
5. Replace gasket E.
6. Tighten the drain oil plug D (tightening torque at 50 Nm).
7. Perform the operations from point 2 to 5 of Par. 6.2.
8. Add the type and amount of oil recommended
(Tab. 2.1 Tab. 2.2).
and
9. If the plug A is not accessible, use the oil filler cap C.
• Do not exceed the MAX level on the dipstick.
EN
30

INFORMATION ABOUT REPLACEMENTS

Before proceeding with operation, read
•
Important
appropriate container.
oil disposal, refer
and SCRAPPING).
Important
Danger
Important
A
6.1
(For
to
6.2
6.3
Par. 3.2.2
E
D
D
ED0053030260
B
C
_07
Index
_08