Table of Contents
Advertisement
Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
6.1 Engine oil replacement
Important
• Place engine on horizontal surface to ensure accurate
measurement of oil level.
NOTE:
Perform this operation with warm engine,
to get a better fluidity of the oil and get
a full discharge of oil and impurities
contained in it.
1. Loosen the oil filler cap A.
2. Remove the oil dipstick B (Fig. 6.3).
3. Remove oil drain plug D from pump E.
4. Start pump E and drain the oil in the engine.
5. Drain
oil
in
an
(For
the
exhausted
Par. 6.9 DISPOSAL
and SCRAPPING).
6. Tighten the drain oil plug D (tightening torque at 10 Nm).
7. Perform the operation described in
8. Add the type oil recommended
9. If the plug A is not accessible, use the oil filler cap C.
10. Fit and remove the oil dipstick B to check the level. Pour
in fluid until reaching the MAX level mark.
11. Upon completion, reinstall the oil dipstick B completely.
12. Tighten the cap A or C.
Important
• Do not exceed the MAX level on the dipstick.
• Do not use the engine with the oil level below the MIN.
ED0053030870
_04
INFORMATION ABOUT REPLACEMENTS
Danger
Important
Before proceeding with operation, read
appropriate
container.
oil
disposal,
refer
to
Par.
6.2.
(Tab. 2.1
and
Tab.
2.2).
Par. 3.2.2
A
6.1
A
6.2
B
6.3
6
D
E
C
B
MAX
MIN
29
EN
Advertisement
Table of Contents
