Contec CONPROSYS nano CPSN-PCB271-S1-041 Reference Manual page 145

Table of Contents

Advertisement

 CPSN-DI-16BCL
Item
Digital filter
Count edge
Count operation
Count value setting
Comparison value setting
Count value zero clear
Status detection
Saving function of count value
 CPSN-AI-2408LI
Item
Analog input method
Analog input range
Channel to use
Input data range
Power supply noise (50/60Hz)
rejection *2
Channel
Power supply noise
switching
rejection (Disabled)
rate *2 *3
Power supply noise
rejection (Enabled)
Resolution
The number of channels
Error detection
Switch detect
LED indicator *1
*1
Only even-numbered LEDs are used when setting to the differential inputs. (CH0=LED 0, CH1=LED 2 ...)
*2
This setting differs depending on the used firmware.
*3
The cut-off frequencies of the digital filter are listed below.
CPSN-PCB271-S1-041 Reference Manual (Software)
0 ms - 1000 ms
Rise, Fall, Both
Set operation status by using PLC program.
Setting value: Stop, Start
Set an arbitrary value to counter by using PLC program.
Set a value to compare with counter by using PLC program.
Zero-clear counter by using PLC program.
Count match status, Carry status
The current value is saved upon shutting down the power
or rebooting.
Single-ended input, Differential input
±10V, ±5V, ±2.5V, 0 - 10V, 0 - 5V,
±20mA, 0 - 20mA
CH0 - CH7
The minimum value and the maximum value of the
input data can be set by user.
Disabled, Enabled
319 msec, 200 msec, 100 msec, 50 msec,
25 msec, 12.5 msec, 6.25 msec, 3.13 msec,
1.67 msec, 0.833 msec, 0.417 msec, 0.208 msec
59.9 msec, 50 msec, 40 msec, 36.7 msec
24bit
Single-ended input: 8 channels
Differential input: 4 channels
Overvoltage detection, Low voltage detection,
Effective range detection.
Setting items on the web setting page differ
according to the switch status.
OFF
Indicates it is not set as the channel to be used or
is set to the differential input.
ON
Data are properly entered.
Flashing
Detected an error.
Appendix
Contents
Contents
— 145 —
Default
1 ms
Rise
Stop
0
0
-
-
-
Default
Single-ended input
±10V
Use all
-10.0 - +10.0
Enabled
40 msec
-
-
-
-
-
-
-

Advertisement

Table of Contents
loading

Table of Contents