Cisco SCE 2000 Quick Start Manual page 72

SCE 2000 Operational Status
Table 9-1
SCE 2000 Operational Status
Warning
Failure
Cisco SCE 2000 4xGBE Quick Start Guide
9-2
SCE 2000 Operational States (continued)
Description
SCE 2000 is fully operational (as
above) but one of the following
occurred:
Line ports (GBE ports) to
•
the link are down
Management port link is
•
down
Temperature raised above
•
threshold
Voltage not in required
•
range
Fans problem
•
Power supply problem
•
Insufficient space on the
•
disk
Note
System is in Failure state after
Boot due to one of the following
conditions:
• Power on test failure
• Three abnormal reboots in
less than 20 minutes
• Platform configured to enter
Failure mode consequent to
failure-induced reboot (this
is configurable using CLI
command)
Note
Chapter 9
If the condition that
caused the SCE 2000 to
be in Warning state is
resolved (for example,
link is up) the SCE 2000
reverts to Operational
state.
Depending on the cause
of failure, the
management interface
and the platform
configuration may or
may not be
active/available.
Troubleshoot Startup Problems
Status LED State
Flashing orange
Red
OL-7820-06