Cisco SCE 2000 Quick Start Manual page 35
Hide thumbs
Also See for SCE 2000:
- Configuration manual (512 pages) ,
- Installation and configuration manual (144 pages)
Table of Contents
Advertisement
Chapter 4
Connect the Management Interfaces and Perform Initial System Configuration
Type the number of the Access Control List to be configured (1 through 99) and press Enter.
Step 3
Note that there is no default for this parameter.
Begin adding entries to the selected list.
Step 4
Indicate whether this entry is permitted access or denied access.
•
To permit access press Enter.
•
To deny access type
Step 5
Type the IP address to be added to this list, and press Enter.
Note that there is no default for this parameter.
Enter IP address or the word 'any' to denote any IP address:
Step 6
If you entered a specific IP address, enter the wildcard bits to define a range of IP addresses and press
Enter. (See
To define an individual IP address, type 0.0.0.0and press Enter.
There is no default for this parameter.
Enter wildcard bits:
Step 7
The maximum number of entries in an ACL is 20.
If the "any" option was used, no other IP addresses may be added to the list.
•
To add more entries, type
Would you like to add another entry to this list? [no]:y
Enter up to 20 entries as described in step 5 and step 6.
•
•
When all entries have been added, press Enter
Would you like to add another entry to this list? [no]:
When all entries are added to one list, you are asked whether you would like to create another ACL. You
Step 8
may define up to 99 ACLs.
To create another ACL, type
•
Would you like to configure another list? [no]: y
•
Enter up to 20 IP addresses in this new ACL, as described in step 5 and step 6.
•
When all ACLs have been created, press Enter.
Would you like to configure another list? [no]:
•
You are now prompted to assign the desired ACLs to restrict IP and Telnet access.
Step 9
Restrict IP access to the SCE 2000 by assigning the appropriate ACL.
Type the number of the ACL to be assigned to IP access and press Enter.
To accept the default ACL, press Enter.
Enter IP access-class [0]:
Step 10
Restrict Telnet access to the SCE 2000 by assigning the appropriate ACL.
Type the number of the ACL to be assigned to the Telnet interface and press
To accept the default ACL, press
Enter Telnet access-class [0]: 2
OL-7820-06
and press Enter.
n
Entry
Formats.)
and press Enter
y
and press Enter
y
Enter
.
Cisco SCE 2000 4xGBE Quick Start Guide
Perform the Initial System Configuration
.
Enter
4-15
Advertisement
Table of Contents
