Example; Step 2: Configuring The Hostname; Step 3: Setting The Passwords - Cisco SCE 2000 Quick Start Manual

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
Configure the IP address.
Step 1
The current IP address is displayed.
•
•
Step 2 Configure the subnet mask.
The current subnet mask is displayed.
•
•
Configure the default gateway.
Step 3
The current IP address of the default gateway is displayed.
•
•

Example

The following example displays a typical configuration of the IP address (10.1.5.109), subnet mask
(255.255.0.0), and default gateway (10.1.1.3).
Since the IP address and the subnet mask are related, when the IP address is changed, there is no longer
a default value of the subnet mask, and it must be entered explicitly.
Enter IP address [10.1.1.201]:10.1.5.109
Enter IP subnet mask:255.255.0.0
Enter IP address of default gateway [10.1.1.3]:

Step 2: Configuring the Hostname

The hostname is used to identify the SCE 2000. It appears as part of the CLI prompt and is also returned
as the value of the MIB-II object sysName.
The maximum length is 20 characters.
The default hostname is SCE 2000 .
Step 1 Specify the hostname for the SCE platform.
The default hostname is displayed.
•
•

Step 3: Setting the Passwords

Configure the passwords as follows:
OL-7820-06
To accept the displayed value, press Enter.
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
To accept the displayed value, press Enter.
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
To accept the displayed value, press Enter.
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
To accept the displayed value, press Enter.
To change the value, type any desired character string and press Enter.
Enter hostname [SCE 2000]:
Perform the Initial System Configuration
Cisco SCE 2000 4xGBE Quick Start Guide
4-7