Step 5: Configuring The Dns Settings - Cisco SCE 2000 Quick Start Manual

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration

Step 5: Configuring the DNS Settings

The DNS configuration menu defines the IP address of the domain name server, which is used for DNS
lookup, as well as the default domain name, which is used to complete unqualified host names.
You may choose to skip the DNS configuration menu if you wish to accept all default values.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Step 1 Enter the DNS settings menu.
Would you like to enter the DNS configuration menu? [no]: y
Type y and press Enter.
The DNS settings dialog begins.
Step 2 Enable or disable DNS lookup.
•
•
If you choose to disable DNS lookup, skip the rest of this section and go to . The rest of the dialog is not
presented, as it is irrelevant when DNS lookup is disabled.
Type the default domain name to be used, and press Enter.
Step 3
Note that there is no default domain name.
You may accept the default domain name or enter a new one.
Enter default domain name []:
Configure the primary domain name server .
Step 4
Type the IP address of the primary domain name server and press Enter.
Enter Primary DNS IP address:
Note that there is no default for this parameter.
Step 5 Configure any additional domain name servers.
You may configure up to three domain servers.
Would you like to add another Name Server? [no]:
•
•
You are asked to enter the IP address of the next domain name server.
Enter Secondary DNS IP address:
OL-7820-06
Enter the DNS settings menu.
Enable or disable DNS lookup.
Type the default domain name to be used, and press Enter.
Configure the primary domain name server .
Configure any additional domain name servers.
Exit the dialog.
To enable DNS lookup, press Enter.
To disable DNS lookup, type
Enable IP DNS-based hostname translation? [yes]:
To exit the DNS settings dialog, press Enter.
To add another domain server, type y and press Enter.
and press Enter.
n
Cisco SCE 2000 4xGBE Quick Start Guide
Perform the Initial System Configuration
4-11