Cisco SCE 2000 Quick Start Manual page 15

Chapter 2 Rack-Mount the SCE 2000
SUMMARY STEPS
1.
2.
3.
4.
5.
DETAILED STEPS
Make sure that the rack brakes are locked or that the rack is otherwise stabilized.
Step 1
Figure 2-7
Position the SCE 2000 so that the front end is closest to you, and lift it carefully to place it into the rack.
Step 2
To prevent injury, avoid sudden twists or moves.
Slide the SCE 2000 into the rack, pushing it back until the brackets (installed at the front of the SCE
Step 3
2000 ) meet the mounting strips or posts on both sides of the rack.
OL-7820-06
Make sure that the rack brakes are locked or that the rack is otherwise stabilized.
Position the SCE 2000 so that the front end is closest to you, and lift it carefully to place it into the
rack. To prevent injury, avoid sudden twists or moves.
Slide the SCE 2000 into the rack, pushing it back until the brackets (installed at the front of the SCE
2000 ) meet the mounting strips or posts on both sides of the rack.
While keeping the brackets flush against the posts or mounting strips, align the holes in the brackets
with the holes on the rack or mounting strip.
For each bracket, insert and tighten two appropriate screws to the rack.
Sliding the SCE Platform into the Rack
PWR A
PWR B STATUS BYPASS
MNG 1 MNG 2 Cisco SCE 2000
LINK/ 10/100/ CONSOLE AUX LINK RX TX 4xGBE Series
ACTIVE 1000 LINK/ ACTIVE 1000 10/100/ LINK RX TX
LINK RX TX
RX MM LINK RX TX
TX RX MM TX
RX MM TX
GBE-1 RX MM TX
SUB LINE NET
SUB LINE/CASCADE GBE-2
NET
PW R A
PW R B
STA TUS
BYP ASS
MN G 1
MN G 2
CON SOL
E
LINK / AUX LINK RX
10/1 00/ TX
ACT IVE
1000 LINK / 10/1 00/
ACT IVE
1000
RX
MM
TX
GBE -1
SUB
LINE
1
C is co SC
E 20 00
Se rie s
4x G BE
LINK RX
TX
LINK RX
TX
LINK RX
TX
RX
MM
TX
RX
MM
TX
RX
MM
TX
NET
GBE -2
SUB LINE
/CA SCA DE
NET
2 3
Mount the System to the Rack
Cisco SCE 2000 4xGBE Quick Start Guide
2-5