Cisco SCE 2000 Quick Start Manual page 37

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
•
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
DETAILED STEPS
Enter the SNMP configuration menu.
Step 1
Would you like to enter the SNMP configuration menu? [no]: y
Type
The SNMP configuration dialog begins.
Step 2 Enable SNMP management.
Type
Enable SNMP management? [no]: y
If you choose to disable SNMP management, skip the rest of this section and go to . The rest of the dialog
is not presented, as it is irrelevant when SNMP management is disabled.
Step 3 Configure the SNMP GET community.
1.
2.
Configure additional GET communities.
Step 4
OL-7820-06
Community strings (where an SNMP community string is a text string that acts like a password to
permit access to the SNMP agent on the SCE 2000).
Enter the SNMP configuration menu.
Enable SNMP management.
Configure the SNMP GET community.
Configure additional GET communities.
Configure the SNMP SET community.
Configure additional SET communities.
Configure the SNMP trap managers.
Configure additional trap managers.
Configure the Authentication Failure trap status.
Configure the SCE enterprise trap status.
Specify the system administrator.
and press Enter.
y
and press Enter.
y
Type the SNMP GET community name and press Enter.
The SNMP agent that resides inside the SCE 2000 will respond only to GET requests that use this
community string.
Enter SNMP GET community name:
Note that there is no default for this parameter.
Assign an access list to restrict the SNMP management stations that may use this GET community.
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0' to allow
all:
Perform the Initial System Configuration
Cisco SCE 2000 4xGBE Quick Start Guide
4-17