Perform The Initial System Configuration; Initial System Configuration - Cisco SCE 2000 Quick Start Manual

Perform the Initial System Configuration

•
•
•
•
The above SCE 2000 port parameters are fixed and are not configurable.
Plug the RS-232 serial cable provided with the SCE 2000 into the CON port on the front panel of the
Step 1
SCE 2000.
Connect the other end of the serial cable (with an attached DB-9 connector) to the VT100 compatible
Step 2
local (serial) terminal.
At the console. press Enter several times until the Cisco logo appears on the local terminal and the setup
Step 3
configuration dialog is entered.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' followed by 'Enter' for help.
Use ctrl-C to abort configuration dialog at any prompt.
Use ctrl-Z to jump to the end of the configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to continue with the System Configuration Dialog? [yes/no]: y
Type y and press Enter.
Step 4
Enters the system configuration dialog.
Perform the Initial System Configuration
•
•
•
•
•
•
•
•
•
•
•

Initial System Configuration

•
•
•
Cisco SCE 2000 4xGBE Quick Start Guide
4-2
8 data bits
No Parity
1 stop bits
No flow control
Initial System Configuration
Step 1: Configuring Initial Settings
Step 2: Configuring the Hostname
Step 3: Setting the Passwords
Step 4: Configuring Time Settings
Step 5: Configuring the DNS Settings
Step 6: Configuring the RDR Formatter Destination
Step 7: Configuring Access Control Lists (ACLs)
Step 8: Configuring SNMP
Step 9: Configuring the Topology-Dependent Parameters
Step 10: Completing and Saving the Configuration
The Setup Command
Setup Command Parameters
Example
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
OL-7820-06