Cisco SCE 2000 Quick Start Manual page 41

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
•
•
•
Study the examples that follow to understand the procedure for various topologies.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
DETAILED STEPS
Enter the topology configuration menu.
Step 1
Would you like to enter the Topology configuration menu? [no]: y
•
Specify the connection mode.
Step 2
•
•
Specify the deployment type.
Step 3
•
•
Step 4 Specify the physically-connected-link index.
OL-7820-06
On-Failure behavior — Determines the behavior of the SCE 2000 upon failure, or reboot. One of
the following link modes may be chosen for the SCE 2000 in the cases of failure or reboot.:
Bypass — traffic is bypassed using the internal bypass card.
–
Cutoff — the link is forced down.
–
Admin status after abnormal reboot — This parameter determines whether the SCE 2000 returns
to full operational mode after abnormal (not user-requested) boot, or stays in non-operational mode,
in which the SCE 2000 behaves as in failure mode. This parameter can be set to one of the following:
Operational
–
Non-operational
–
The procedure described below is a presentation of all the questions in the topology configuration.
In actual practice, all questions may not be presented for a particular configuration, depending on
the topology deployed.
Enter the topology configuration menu.
Specify the connection mode.
Specify the deployment type.
Specify the physically-connected-link index.
Specify the SCE 2000 priority.
Specify the On-failure link behavior.
Specify the status of the SCE 2000 after abnormal boot.
Enter your password if prompted.
Type and press Enter.
y
The topology configuration dialog begins.
To define inline connection mode, press Enter.
To define receive-only connection mode, type 2 and press Enter.
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
To specify a Single-SCE Platform deployment, press Enter.
To specify a Cascadedeployment, type
Is this a cascade deployment? [no]:
Perform the Initial System Configuration
and press Enter.
y
Cisco SCE 2000 4xGBE Quick Start Guide
4-21