Step 4: Configuring Time Settings - Cisco SCE 2000 Quick Start Manual

Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
Enter a User password [cisco]: userin
Enter an Admin password [cisco]: mng123
Enter a Root password [cisco]: cistech
Enable passwords encryption? [no]:

Step 4: Configuring Time Settings

The time settings menu configures all time and date related parameters in the system. The time settings
menu includes the following:
•
•
•
•
You must enter the time setting menu in order to configure SNTP settings. You may choose to skip the
time settings menu if you wish to accept all default values.
Unlike all other settings defined in the system configuration, setting the time is done immediately and
Note
not at the end of the setup process.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
DETAILED STEPS
Step 1 Enter the time settings menu.
Would you like to enter the Time settings menu? [no]: y
Type
Configure the time zone name.
Step 2
Type the time zone abbreviation and press Enter.
Enter time zone name [UTC]: CET
Step 3 Specify the offset from UTC.
Type the minutes offset from UTC and press Enter.
Enter time zone minutes offset from UTC: 60
Confirm the local time and date.
Step 4
OL-7820-06
Time zone
Local time
Date
SNTP menu
Enter the time settings menu.
Configure the time zone name.
Specify the offset from UTC.
Confirm the local time and date.
Enter the SNTP configuration menu.
Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
Define the time interval between unicast updates.
Specify an IP address for the SNTP unicast server.
and press Enter.
y
Perform the Initial System Configuration
Cisco SCE 2000 4xGBE Quick Start Guide
4-9