Chapter 4 Connect The Management Interfaces And Perform Initial System Configuration; Connect The Local Console - Cisco SCE 2000 Quick Start Manual

Connect the Management Interfaces and Perform
Initial System Configuration
This section explains how to connect the SCE 2000 platform to a local console and perform the initial
system configuration via the setup wizard that runs automatically. Additionally, this section contains
instructions for cabling the Fast Ethernet Management interface.
Note When installing a cascaded system, it is extremely important to follow the sequence of procedures
outlined in the section Installing a Cascaded System.
•
•
•

Connect the Local Console

Figure 4-1
1
You must first connect the unit to a local console and configure the initial settings for the SCE 2000 to
support remote management. When the initial connection is established, the setup utility will run
automatically, prompting you to perform the initial system configuration.
Make sure that the terminal configuration is as follows:
•
OL-7820-06
Connect the Local Console
Perform the Initial System Configuration
Connect the Management Interface
Connecting to the Local Console
PW R A
PW R B
STA TU S
BY PAS S
MN G 1
MN G 2
CO NS OL
E
LIN K/ AU X
10/1 00/
ACT IVE LIN K/
100 0 10/1 00/
ACT IVE
100 0
2 3
9600 baud
C H A P T E R
C is co S
C E 2 0 0 0
LIN K RX Se rie s
4 xG B E
TX
LIN K RX
TX
LIN K RX
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
RX
MM
TX
RX
MM
GB E-1
TX
SU B
LIN E
NE T
GB E-2
SU B LIN
E/C AS CA
DE NE T
4
Cisco SCE 2000 4xGBE Quick Start Guide
4-1