Step 10: Completing And Saving The Configuration - Cisco SCE 2000 Quick Start Manual

Perform the Initial System Configuration

Step 10: Completing and Saving the Configuration

When you have completed the entire configuration, the system checks for errors. If errors are found, a
warning message appears. When the configuration is error-free, you may apply and save it.
To complete and save the configuration, complete the following steps:
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Step 1 Review the new configuration.
The system informs you that data collection is complete.
We recommend that you view the entire new configuration before it is applied.
Type
Note that there is no default.
If there are no errors, go to step 3.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]: y
Step 2 View errors (if any).
If any errors are detected, you may choose to view them.
Press Enter.
Found errors in the new configuration, would you like to view them? [yes]:
The following errors were found:
Warning - RDR formatter destination 10.1.1.1 is not allowed in the IP access-class.
Step 3 Apply and save the configuration.
You are asked whether to apply and save the configuration.
Apply and Save this configuration? [yes/no]:
•
•
Confirm saving and applying the configuration.
Step 4
If there are no errors, the system requests confirmation of either a yes or no answer, in order to prevent
mistakes.
Type the appropriate answer (y or n) and press Enter.
The running configuration would be overwritten by the changes you have just entered, are
you sure? [yes/no]:
The selected action is carried out by the system.
Cisco SCE 2000 4xGBE Quick Start Guide
4-24
Review the new configuration.
View errors (if any).
Apply and save the configuration.
Confirm saving and applying the configuration.
Save the configuration to a remote location.
This completes the procedures for initial configuration of the SCE 2000 platform.
and press Enter.
y
To apply and save the configuration, type
Setup procedure aborted, no configuration changes made.
If the setup is aborted, the dialog is ended.
Chapter 4 Connect the Management Interfaces and Perform Initial System Configuration
and press Enter.
y
OL-7820-06