Table of Contents
Advertisement
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
12.11 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The top lamp
1. Turn the lamp glass cover to remove
it.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or op‐
erate the oven.
The oven does not heat
up.
The oven does not heat
up.
2. Remove the metal ring and clean the
3. Replace the lamp with a suitable 300
4. Attach the metal ring to the glass
5. Install the glass cover.
The side lamp
1. Remove the left shelf support to get
2. Use a Torx 20 screwdriver to remove
3. Remove and clean the metal frame
4. Replace the lamp with a suitable 300
5. Install the metal frame and the seal.
6. Install the left shelf support.
Possible cause
The oven is not connected
to an electrical supply or it
is connected incorrectly.
The oven is deactivated.
The necessary settings are
not set.
glass cover.
°C heat-resistant lamp.
cover.
access to the lamp.
the cover.
and the seal.
°C heat-resistant lamp.
Tighten the screws.
Remedy
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
Activate the oven.
Make sure that the settings
are correct.
ENGLISH
59
Advertisement
Table of Contents
