Registering A Unit - Panasonic KX-TGJ420E Operating Instructions Manual

2
Enter the current 4-digit base unit PIN
(default: "0000").
3
Enter the new 4-digit base unit PIN. a
MOKN
4
MbN: "Yes" a MOKN a MOFFN

Registering a unit

Operating additional units
Additional base units
Handsets can be registered to up to 4 base
units, allowing you to add additional base units
and extend the area in which your handset(s)
can be used. If a handset moves out of range
of its base unit when "Auto" is selected on
base unit (page 39), it looks for another
base unit to make or receive calls. A base unit
and the handsets it communicates with is
called a "radio cell".
Note:
R Calls are disconnected when the handset
moves from one radio cell to another.
Registering a handset to a base
unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
MMENUN (right soft key) #130
2
MbN: Select a base unit number. a MOKN
R This number is used by the handset as
a reference only.
3
Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing,
press MLOCATORN again to stop, then
repeat this step. (KX-TGJ422/
KX-TGJ423/KX-TGJ424)
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
4
Handset:
MOKN a Wait until "Base PIN" is
displayed. a Enter the base unit PIN
(default: "0000"). a MOKN
R If you forget your PIN, see page 53.
Selecting a base unit
When "Auto" is selected, the handset
automatically uses any available base unit it is
registered to. When a specific base unit is
selected, the handset makes and receives
calls using that base unit only. If the handset is
out of range of that base unit, no calls can be
made.
1
MMENUN (right soft key) #137
2
MbN: Select the desired base unit number,
or "Auto". a MOKN
Important:
R When viewing the phonebook, caller list,
etc., only the entries that are stored in the
base unit that the handset is currently
connected to are displayed.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
MMENUN (right soft key) #131
R All handsets registered to the base unit
are displayed. (KX-TGJ422/
KX-TGJ423/KX-TGJ424)
2
MbN: Select the handset you want to
cancel. a MOKN
3
MbN: "Yes" a MOKN a MOFFN
Cancelling a base unit
A handset can cancel a base unit that it is
registered to. This allows the base unit to end
its wireless connection with the system.
1
MMENUN (right soft key) #139
2
MbN: Select the base unit you want to
cancel. a MOKN
3
MbN: "Yes" a MOKN a MOFFN
Programming
39