Other Programming - Panasonic KX-TGJ420E Operating Instructions Manual

Programming
n When monitoring from an outside line:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialling.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 4". You can customise the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 38).
1
MMENUN (right soft key) #104
2
Enter the desired name (10 characters
max.).
3
MOKN a MOFFN
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
1
MMENUN (right soft key) #105
2
MbN: Select the desired setting. a MOKN
a MOFFN
Call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1
MMENUN (right soft key) #256
38
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
2
Enter the base unit PIN (default: "0000").
R If you forget your PIN, see page 53.
3
MbN: Select the handsets to be restricted.
a MSELECTN
R " " is displayed next to the selected
handset numbers.
R To cancel the selected handsets:
MbN: Select the handset. a Press
MSELECTN again. " " disappears.
4
MOKN
5
MbN: Select a memory location. a MOKN
6
Enter the phone number or area code to
be restricted (8 digits max.). a MOKN a
MOFFN
Enhancing security for phone
calls
You can increase the security of phone
conversations by setting this feature to
"Enhanced". When "Enhanced" is selected,
is displayed. The default setting is
"Normal".
1
MMENUN (right soft key) #729
2
MbN: Selected the desired setting. a MOKN
3
MOFFN
Note:
R If you set repeater mode to "On"
(page 40):
– Security is set to "Normal" and
displayed.
– "Security" is not displayed in the
display menu (page 32).
R When enhanced security is enabled, sound
may cut in and out during conversations.
Changing the base unit PIN
Important:
R If you change the PIN (Personal
Identification Number), please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, see
page 53.
1
MMENUN (right soft key) #132
is