Panasonic KX-TGJ420E Operating Instructions Manual page 40

Programming
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
MMENUN (right soft key) #138
2
MbN: Select the desired setting. a MOKN
a MOFFN
Registering the DECT repeater
(KX-A405/KX-A406) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Press and hold MLOCATORN for about 5
seconds.
2
DECT repeater:
Connect the AC adaptor, then wait until
the indicator and
green.
3
Base unit:
To exit the registration mode, press
MLOCATORN.
40
indicator light
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333