Registering A Handset To A Base Unit - Panasonic KX-TGA470C Installation Manual

TGA470C(en).fm Page 4 Tuesday, November 22, 2011 5:52 PM
Charge for about 7 hours.
L When the batteries are fully charged, "Fully charged" is displayed.
Note:
L When the language selection is displayed after installing the batteries
for the first time, you can select your desired language.
{r}: Select the desired setting. s {SAVE} s {OFF}
L If the batteries are fully charged, but the operating time seems to be
shorter, clean the battery ends (S, T) and the charge contacts with a
dry cloth and charge again.

Registering a handset to a base unit

1
Base unit:
Press and hold {LOCATOR} for about 5 seconds.
L Depending on the base unit, a registration tone sounds.
L If all registered handsets start ringing, press {LOCATOR} again to
stop, then repeat this step.
2
Handset:
Place the handset on the base unit or charger, then wait until a long
beep sounds and w is displayed.
Note:
L If an error tone sounds, or if _ is displayed, register the handset
according to the base unit's operating instructions.
4
Rechargeable
Ni-MH ONLY
Confirm
"Charging"
is displayed.