Husqvarna R112C Workshop Manual page 38

9.5.2 To remove and install the hydrostatic
transmission(R112C, R115C)
1. Put supports below the product. Refer to
supports below the product on page 6 .
2. Remove the rear wheels. Refer to
install the wheels on page 23 .
3. Remove the hydrostatic transmission cable. Refer to
To replace the hydrostatic transmission cable on
page 40 .
4. Remove the clutch control.
5. Remove the transmission belt. Refer to
the transmission belt (R112C, R115C) on page 46 .
6. Remove the hydrostatic transmission cable. Refer to
To replace the hydrostatic transmission cable on
page 40 .
7. Remove the screw on the hydrostatic transmission
lever.
38 - Repair instructions
8. Remove the 5 screws.
To put
To remove and
9. Install in the opposite sequence.
9.5.3 To remove and install the manual
transmission
1. Put supports below the product. Refer to
2. Remove the rear wheels. Refer to
3. Remove the transmission belt. Refer to
To replace
4. Remove the brake cable spring (A).
5. Loosen the locknuts (B) and remove the brake cable
supports below the product on page 6 .
install the wheels on page 23 .
the transmission belt (R112C, R115C) on page 46
To replace the transmission belt (R112C5) on
or
page 47 .
C
B
(C).
To put
To remove and
To replace
A
1342 - 002 -