Husqvarna R112C Workshop Manual page 29

14. Remove the engine.
15. Install in the opposite sequence.
9.2.5 To remove and install the engine (R112C5,
R115C)
1. Remove the battery. Refer to
the battery on page 34 .
2. Remove the frame cover. Refer to
install the frame cover on page 20 .
3. Remove the engine cover. Refer to
engine cover on page 21 .
4. Remove the rear engine cover. Refer to
the rear engine cover on page 22 .
5. Remove the side covers. Refer to
install the side covers on page 21 .
6. Remove the fuel tank cover. Refer to
fuel tank cover on page 21 .
7. Remove the fuel tank. Refer to
install the fuel tank on page 37 .
1342 - 002 -
To remove and install
To remove and
To remove the
To remove
To remove and
To remove the
To remove and
8. Disconnect the engine pin connector, the ground
cable and the starter motor cable.
9. Disconnect the throttle cable.
10. Remove the muffler.
a) For model R112C5 refer to
install the muffler (R112C5) on page 30 .
b) For models R115C refer to
the muffler (R115C) on page 31 .
11. Remove the engine belt. Refer to
engine belt on page 45 .
To remove and
To remove and install
To replace the
Repair instructions - 29