Husqvarna R112C Workshop Manual page 22

9.1.1.14 To remove the rear engine cover
1. Remove the engine cover. Refer to
engine cover on page 21 .
2. Remove the engine side covers. Refer to
the engine side covers R115C on page 21 .
3. Remove the 2 screws (A).
B
C
4. Push and hold the catch (B) on one side of the rear
engine cover.
5. Push the catch of the rear engine cover through the
bracket (C).
6. Remove the rear engine cover.
9.1.2 Throttle cable
9.1.2.1 To do a check of the throttle cable
Make sure that the engine speed changes when the
throttle is changed. Do a check that the engine gets the
correct speed at full throttle. See
52
9.1.2.2 To adjust the throttle cable (R112C)
Note: The throttle cable looks different on different
engine models.
1. Loosen the clamp screw for the cable casing on the
throttle cable and move the throttle control to the full
throttle position.
2. Make sure that the throttle cable is attached to the
correct hole.
22 - Repair instructions
To remove the
To remove
A
Technical data on page
3. Pull the cable casing on the throttle cable away from
the hole and tighten the clamp screw.
9.1.2.3 To adjust the throttle cable (R112C, R115C)
Note: The throttle cable looks different on different
engine models.
1. Loosen the clamp screw for the cable casing on the
throttle cable and move the throttle control to the full
throttle position.
2. Make sure that the throttle cable is attached to the
correct hole.
3. Pull the cable casing on the throttle cable away from
the hole and tighten the clamp screw.
9.1.3 Parking brake
9.1.3.1 To adjust the parking brake cable (R112C,
R115C)
WARNING: An incorrectly adjusted parking
brake cable can cause decreased brake
capacity.
Note: The parking brake cable is correctly adjusted
when there is no play in the cable.
1. Loosen the locknuts (A).
2. Adjust the parking brake cable with the adjustment
screw (B).
3. Tighten the locknuts (A).
A
A
B
1342 - 002 -