Husqvarna R112C Workshop Manual page 24

3. Remove the snap ring.
4. Pull off the wheel from the axle.
5. Collect the spacer sleeve and washers from the
axle.
6. Install in opposite sequence.
9.1.5 Rear axle
9.1.5.1 To disassemble and assemble the articulated
steering joint
1. Put chocks in front of and behind the front wheels.
2. Put supports below the front carriage in front of the
articulated steering joint.
CAUTION: Do not cause damage to the
cables.
3. Put supports below the rear carriage. Refer to
supports below the product on page 6 .
4. Remove the engine cover. Refer to
engine cover on page 21 .
5. Remove the side covers. Refer to
install the side covers on page 21 .
6. Remove the frame cover. Refer to
install the frame cover on page 20 .
7. Remove the engine belt. Refer to
engine belt on page 45 .
8. Remove the transmission belt. Refer to
the transmission belt (R112C, R115C) on page 46 .
9. Remove the main belt. Refer to
belt on page 48 .
24 - Repair instructions
To put
To remove the
To remove and
To remove and
To replace the
To replace
To replace the main
10. Remove the steering cables.
11. Remove the screw of the articulated steering shaft
from below.
12. Lift the rear end of the product with a jack assembly.
1342 - 002 -