Table of Contents
Advertisement
543
Use the "H" option to set hardware information by typing the character
H
. This will display the hardware information that can be changed as
shown in.
4.
To choose the boot from a fallback image, type the command:
rflag=1
Save
5.
Type
to save the hardware information.
Exit
6.
Type
to exit the hardware information menu.
7.
Type J to boot the image. In this case it will boot from a fallback
image.
8.
In case you wish to later move back to a normal image, repeat the
above the steps with one difference for step 4, where you should
use the command rflag=0
normal firmware image.
instead
of rflag=1 to boot with a
Advertisement
Chapters
Table of Contents
