Guide Bar Bolts - Husqvarna 555 Workshop Manual

4. Use the crankcase assemble tool to push the
crankcase to the correct position. Refer to
tools on page 9 .
5. Attach the 6 screws (C). Tighten them in turn to the
correct torque. Refer to
D
CAUTION: Make sure that the crankshaft
rotates freely.
6. Carefully cut off the gasket along the cylinder
interface. Make sure that you do not cause damage
to the crankcase surface.
56 - Repair instructions
Servicing
Servicing data on page 7 .
x4
C
7. Assemble the carburetor bottom plate to the
crankcase and tighten the 4 screws (D) to the
correct torque. Refer to
8. Install the oil tank cap assembly
9. Assemble the remaining parts as given in
access to the crankshaft and crankcase on page 51 .

7.20 Guide bar bolts

7.20.1 To remove the guide bar bolts
1. Drain the oil tank.
2. Remove the clutch cover.
3. Remove the guide bar and saw chain.
4. Hit the guide bar bolts until they fall into the oil tank.
5. Remove the guide bar bolts from the oil tank.
Servicing data on page 7 .
To get
1540 - 001 -