Starter - Husqvarna 555 Workshop Manual

7.7.4 To disassemble and assemble the rear
handle
1. Remove the screw and the handle cover. If the
product has heated handles, refer to
install the heated rear handle on page 23 .
2. Use a flat screwdriver to push out and remove the
throttle trigger lockout.
3. Remove the pin that holds the throttle trigger.
1540 - 001 -
4. Remove the throttle wire and the throttle trigger.
To remove and
5. Assemble in the opposite sequence.
7.7.5 To clean and examine the handle and throttle
trigger
1. Carefully clean and examine all parts.
2. Replace parts that are damaged. Always use
original spare parts.
3. Make sure that the spring in the throttle trigger is not
damaged and keeps all its tension.

7.8 Starter

7.8.1 To disassemble the starter unit
1. Loosen the 4 screws (A).
2. Remove the starter (B) and the cooling air conductor
(C).
WARNING: Use approved eye protection. The
recoil spring can eject and cause injuries.
C
B
A
Repair instructions - 25